\u2022 This system consists of two parts, Panel Set – A and Panel Set – B.:
\n\u2022 Panel set A for wiring and panel set B for PV array connection<\/p>\n
Panel Set A<\/strong><\/p>\n Approx. Dimensions: L 850mm X W 350mm X H 650mm Panel Set B<\/strong><\/p>\n PV Module and array requirement are listed below: Technical Specifications: \u2022 This system consists of two parts, Panel Set – A and Panel Set – B.: \u2022 Panel set A for wiring and panel set B for PV array connection Panel Set A Approx. Dimensions: L 850mm X W 350mm X H 650mm Balance of System components pre-mounted Trunking and ducting to facilitate […]<\/p>\n","protected":false},"featured_media":17916,"template":"","meta":{"_acf_changed":false,"_monsterinsights_skip_tracking":false,"_monsterinsights_sitenote_active":false,"_monsterinsights_sitenote_note":"","_monsterinsights_sitenote_category":0},"product_cat":[125],"product_tag":[],"class_list":["post-17909","product","type-product","status-publish","has-post-thumbnail","product_cat-solar-power-lab","first","instock","shipping-taxable","product-type-simple"],"acf":[],"yoast_head":"\n
\nBalance of System components pre-mounted Trunking and ducting to facilitate wiring and routing of cables-
\nMinimum Components pre-mounted on board for off Grid PV system circuit:
\n\u2022 DC array Isolator with MC4 connector terminated to receive external
\n\u2022 Solar cable connection to PV Solar Array
\n\u2022 Sets of MCBs for DC Array and Controller protection
\n\u2022 Charge Controller with provision for battery charging, DC external loads and connection to inverter; Have
\ndisplay value on Voltage, current.
\n\u2022 Battery Disconnect Switch
\n\u2022 Battery 100 AH ,12V deep cycle Lead Acid battery
\n\u2022 AC Inverter of 1KVA, input 12V\/24V, output 230V, 50 Hz, type pure sine wave type
\n\u2022 AC Isolator
\n\u2022 Provision for earthling terminations
\n\u2022 Control panel are provided with power flow diagrammatic representation
\nCable provided must be of appropriate colour codes and sizes meeting to approve IEC PV regulation
\nrequirement.<\/p>\n
\nFour PV Polycrystalline modules pre-mounted and connected with following requirement on each PV module
\nPV Panel Total Capacity -1kW
\nEach module to be connected with bypassed diode in junction box and which is accessible for inspection and
\ntesting. The positive and negative terminals are terminated in MC 4 connectors and properly labelled terminal
\n\u2018+ve\u2019 or \u2018-ve\u2019 wires.
\nParallel MC4 connectors with solar wire and MC 4 straight connector assembly to be of sufficient length and
\nnumber to be able to connect the 4 modules in series or parallel configuration for training.
\nThe modules are to be mounted on inclinable plane which is lockable at different angles to horizontal position
\nrespectively.<\/p>\n","protected":false},"excerpt":{"rendered":"